4.Basic Operation
4
32
4.8.1 Monitor Function
In case the receiving signal is weak and the audio is intermittently cut off by the
squelch, press the MONI key. As long as this key is pressed, the squelch including
TSQ/DCS unmutes making the audio easier to hear.
• The squelch is unmuted while the MONI key is pressed, regardless of the squelch
level setting.
• This function unmutes the squelch even if the DCS and Tone Squelch functions are
set.
1. Select the frequency by using the dial or keypad.
2. Press the PTT key.
The red TX indicator turns on while transmitting.
3. While holding down the PTT key, speak into the unit at normal voice from the
distance of 5cm (2").
4. Release the PTT key to receive.
4.9.1 Selecting the Output Level
Press the FUNC key, and while
is displayed on the LCD, press the
key to
switch transmission power output.
Every time you repeat this operation, the display changes as follows depending on the
output level selected:
•
is displayed with
on the power meter. (Low power output)
•
is displayed with
on the power meter. (Middle power output)
• Nothing is displayed with
on the power meter. (High power output)
The initial setting is low power.
IMPORTANT NOTE:
The output level can't be altered while transmitting.
IMPORTANT NOTE:
• To transmit a tone-burst signal, press the MONI key while holding down the
PTT key.
• Speaking too loud, too close or too far from the unit may distort the audio.
• "OFF" appears on the display and a beep sounds when the PTT key is pressed
with the TX frequency set out of the TX range. You can not transmit in this state.
• The communication distance changes by the environment.
Transmitting
4.9
Содержание DJ-V57
Страница 69: ...The following table lists available characters ...
Страница 70: ...Memory Mode Structure ...
Страница 71: ......
