Steps
1.
Route the cables through the slot on the front panel and align and clip the front bezel into place.
2.
Align the screw hole of the cable management cover with the screw hole on the chassis.
3.
Replace the two screws (#6-32) that secure the cable management cover to the chassis.
4.
Connect the USB cables, LED controller cable and audio cable to the system board and route the cables through the routing
guides on the inside of the chassis.
5.
Route the power-button module cable through the routing guides on the chassis and connect the power-button module cable.
6.
Place the computer in an upright position.
7.
Route the tron-light cable through the routing guides on the chassis and connect the tron-light cable.
8.
Rotate the power-supply unit cage towards the chassis.
9.
Slide the power-supply unit cage release latches towards the locked position.
Next steps
1.
, as applicable.
2.
.
3.
.
4.
.
5.
Follow the procedure in
After working inside your computer
.
64
Содержание Aurora R9
