NOTE: Note the routing of all cables as you remove them so that you can route them correctly after you replace the
power-supply unit.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the removal procedure.
Steps
1.
Remove the two screws (#6-32) that secure the power-supply unit bracket to the power-supply unit cage.
2.
Lift the power-supply unit bracket off the power-supply unit cage.
3.
Press the releasing clip on the power-cable connectors and disconnect all the power cables from the power-supply unit.
4.
Remove the four screws (#6-32) that secure the power-supply unit to the chassis.
5.
Slide and lift the power-supply unit, along with the cables, off the chassis.
Installing the 850 W power-supply unit
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
32
Содержание Aurora R9
