Security
password controls access to the
system setup utility.
System Password
Allows you to set the system
password. The system password
controls access to the computer at
boot.
HDD Password Status
Displays if the HDD password is
clear or set.
Default: Not set.
HDD1 Password Status
Displays if the HDD password is
clear or set.
Default: Not set.
HDD2 Password Status
Displays if the HDD password is
clear or set.
Default: Not set.
HDD3 Password Status
Displays if the HDD password is
clear or set.
Default: Not set.
Password Change
Allows you to permit or deny system
password or HDD password
changes. Default: Permitted
Computrace
Enable or disable the BIOS module
interface of the optional Computrace
Service from Absolute Software.
HDD protection
Allows you to set, change, or delete
the hard-disk drive password.
Default: Disabled.
Firmware TPM
Enable or disable the firmware TPM.
Default: Enabled.
UEFI Firmware Capsule Updates Enable or disable BIOS updates
through UEFI capsule update
packages.
Default: Enabled.
189
Содержание Area-51 R3 Threadripper Edition
