Replacing the front bezel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance
Procedure
1
Align the tabs from inside the chassis on the right and left side and place the
front bezel and snap it in place.
2
Connect the top tron light-cables to the front bezel.
3
Connect the bottom tron light-cables to the front bezel.
4
Replace the screw (6-32x5.2) from inside, securing the front bezel to the
right side of the chassis.
5
Replace the two screws (6-32x5.2) from inside, securing the front bezel to
the left side of the chassis.
6
Replace the four screws (#6-32x6) that secure the front bezel to the bottom
and top of the chassis.
Post-requisites
1
Replace the
.
2
Replace the left and right side-panels. See “
”.
3
Replace the
.
146
Содержание Area-51 R3 Threadripper Edition
