ALGE-Timing TIMY2, Руководство пользователя

Страница: 17 / 32

Manual
TIMY2 - General
Page 17
Display without external supply
Display with external supply
8 Info Mode
Pressing the buttons opens the info mode. Im-
portant data is displayed.
•
external power supply Yes or No
•
TIMY2 program version
•
TIMY2 boot version
•
battery voltage
•
output voltage
•
integrated printer
•
hardware number
•
state of timing channels (C0, C1, C2, C3)
9 GPS Synchronisation
It is possible to synchronise the TIMY2 with a GPS mouse (GPS-TY). The synchronisation can
be effected with all programs and is a up to the 1/10 000 seconds exactly.
•
The GPS mouse (picture: GPS 18LVC) needs no exter-
nal power supply.
•
The RS232 baud rate of the TIMY2 has to be set to 9600
Baud.
•
In the menu <channels> the item <TED-RX> has to be
deactivated.
•
The GPS synchronises the TIMY2. After this the TIMY2
runs with its own precision quartz and the GPS can be
disconnected. The GPS Mouse can now be used to syn-
chronise further devices.
Instead of the day time setting, the display shows as indicated
on the right. As long as it says “NO SIGNAL”, the GPS receiver
is searching for satellites.
When
“OK -UTC +UTC NO” is displayed in the bottom line,
the time for your region can be adjusted with keys <F1> and
<F2>. As soon as the correct time is shown, press <OK>.
Attention!
After receipt of a valid GPS signal, the TIMY2 verifies the check-
sum and measures the duration of the sync signal. If the sync signal is erroneous, the TIMY2
carries out a reset. Thus it is impossible to generate an invalid sync time. If the TIMY2 is sup-
plied by external power, it automatically restarts. In case of operation with internal power, the
TIMY2 turns off and has to be restarted.
Remove the GPS receiver from the TIMY2. Press <OK> to
start the selected program.