16
TO TEST:
Make sure all control valves are in the “OFF” position.
Apply the soap solution described above to all fittings.
Turn the gas supply on.
Check all connections from the supply line, or LP cylinder up to and including the manifold pipe
assembly.
Soap bubbles will appear where a leak is present.
If a leak is present, immediately turn off gas supply, tighten any leaking fittings, turn the gas sup-
ply back on, and recheck.
If you cannot stop a gas leak, turn off the gas supply and call the dealer where you purchased
your oven.
Do not use the Pizza oven until all connections have been checked and do not leak.
Only those parts recommended by the manufacturer should be used on the oven. Substitution
can void the
Artisan
™
Pizza Oven’s warranty.
IMPORTANT NOTE:
ALWAYS CHECK FOR LEAKS AFTER EVERY LP TANK CHANGE.
If a leak is present, or if the connection hose shows signs of wear, these conditions must be corrected
prior to using your oven.
Check all gas supply fittings for leaks before each use. It is handy to keep a spray bottle of soapy water
near the shut-off valve of the gas supply line. Spray all the fittings. Bubbles indicate leaks.
OVEN AND ACCENT LIGHTS:
The oven light button is located on the upper left
side of the front control panel. This switch con-
trols both the oven space light as well as the
front panel accent lights directly above the con-
trol knobs.
LIGHTING INSTRUCTIONS:
BEFORE LIGHTING LP SYSTEMS:
The pressure regulator (
Type QCC1
) and hose assembly supplied with the
Artisan
™
Pizza Oven must
be used. Never substitute regulators for those supplied with the oven. If a replacement is necessary,
contact the factory for proper replacement.
PUSH
FOR
LIGHT FIXTURE
(inside the oven)
ACCENT LIGHTS
(under bullnose)
