11
Fasten the hose connection to the 1/2” FPT x 3/8” ODF (flare fitting) con-
nected to the elbow. (
S
ee Figure # 5
). It is best to use a wrench of the ap-
propriate size to fasten this connection.
Fasten the hose regulator to the LP cylinder by hand tightening the green
connector to the tank valve until the knob stops rotating and it is fixed to the
cylinder’s valve.
RECOMMENDED APPLIANCE AND CYLINDER PLACEMENT:
The
Artisan
™
Pizza Oven should be placed on a non-combustible countertop surface suitable for its
operation. (see page 6 for this information). The LP supply cylinder or tank should never be placed on
the counter next to the oven as radiated heat from the oven could possibly create a hazardous condition
and risk of explosion.
F
or safety, please note of the following instructions:
1. When an LP cylinder and hose is placed close to the unit, a tripping hazard with the hose or cyl-
inder might occur. (
see Figure 6a and 6b
)
2. The length of the hose and the location of the cylinder needs to be such as not to interfere with
the unit operation and if it was to fall to the ground, it will not strike the unit on its downward fall
nor pull the unit sufficiently to cause spillage of liquids or food, should the cylinder be tipped in
any direction.
3. It is recommended to use a standard 20 lbs. LP cylinder (approx. 12” Ø / 18” tall) designed for
vapor extraction marked in accordance of LP gas cylinders and US Department of Transportation
DOT specifications 4BA, 4BW, and 4E. (also approved under Transport Canada specifications
4BAM, 4BWM, and 4EM when necessary) with an ACME thread / OPD (overfill protection de-
vice) installed.
4. Connect and disconnect the hose according to the procedure on page 10 and always check for
gas leaks according to the procedure on page 16 & 17.
5. If the Pizza Oven is not in use, the gas must be turned off at the supply cylinder.
6. Storing the Pizza Oven indoors is permissible only if the cylinder is disconnected and removed
from the Pizza Oven.
Figure # 6a
Figure # 6b
Cylinder placed in
such way that cannot
strike the unit when
falling to the ground.
Cylinder and hose are
placed away from the
hot body of the oven.
DO NOT
place the
cylinder in such a
way that it could
become a tripping
hazard or if tipped.
The cylinder could
drag the unit and
fall in the ground
while operating.
COUNTER
ACCESS DOOR
(optional)
