Alcatel 060170-10, Руководство пользователя

Страница: 138 / 430

Setup and Installation
Page 4-6
AVNDS Dialing Scheme Settings (Required) — The following configuration
data, obtained from the dialing scheme selected as per Step 4, will vary
depending on the dialing scheme.
• voice destination (ports/channels to which VoIP calls are routed)
• voice phone group (telephone numbers that callers may dial)
• voice numbering plan (associated voice phone groups and destinations)
• multiple PSTN connections (*required only for sites using Public Switched
Telephone Network)
Except when local channels are used, all AVNDS commands function with the
H.323 endpoints, e.g., OmniPCX, Cisco Routers, Microsoft NetMeeting.
Convergence Settings (Optional)
• voice signaling channels (e.g., E&M, FXO and FXS signaling protocols;
*required if not using E&M Immediate Start protocol. *Required only in
Europe; FXS ring cadence coefficient and ring cadence ID.
• voice switching daughtercards (e.g., dialing timers)
• coding profiles (codec type, e.g., voice, fax; *required only if connecting to
other type of H.323 device, including OmniPCX 4400 with LIOE (Link Opti-
mizer Ethernet [voice] card, Cisco Router, and Microsoft NetMeeting)
• Voice (VoIP) network (*required only if using H.323 gatekeeper software)
7. Configure the jumpers on the voice daughtercard being installed as required and detailed
in Chapter 2, “VoIP Daughtercards.” Proceed to Step 8 only after the jumpers (if neces-
sary) have been properly configured in the order in which they are presented in
Chapter 2, “VoIP Daughtercards.” Damage to voice daughtercards may result if jumpers
are not properly configured.
8. Turn OFF power to switch, then insert and seat daughtercard configured as per Step 7
above; do not proceed with Step 8 unless jumpers on the card are properly configured.
Refer to Chapter 2, “VoIP Daughtercards,” for configuration details.
For OA 512 with digital daughtercard; insert (DIMMs side up) into empty expansion
slot #4.
For OA 512 with analog daughtercard; insert (FXO, FXS module side up) into empty
expansion slot #4.
For OSR with digital daughtercard; insert (DIMMs side up) into VSX (HSX-H) mother-
board in left most position (connector J17), and (connector J15) for a second card. Once
voice daughtercard(s) seated, locate VSX into empty slot (2-9); MPX must be installed in
slot (1).
For OSR with analog daughtercard; insert (FXO, FXS module side up) into VSX (HSX-H)
motherboard in left most position (connector J17), and (connector J15) for a second card.
Once voice daughtercard(s) seated, locate VSX into empty slot (2-9); MPX must be
installed in slot (1).
9. Connect port on voice daughtercard to PBX or other device using straight-through or
cross-over cable (straight-through recommended).
For digital voice daughtercard only; if communication link error occurs between switch
and PBX or Key Set, turn OFF switch, remove daughtercard, and then flip blue T1 cross-
over toggle switch on the top side of the board to swap the T1 transmit and receive
connections for the designated port.