Alamo Industrial A-Boom, Руководство оператора

Страница: 144 / 164

OPERATION
A-BOOM 03/09 Operation Section 3-48
©2009 Alamo Group Inc.
OPERA
T
ION
TROUBLESHOOTING GUIDE
HYDRAULIC CYLINDER NOT WORKING
- Check level of hydraulic fluid (see sight gauge on tank). Check to
see if pump is functioning properly by attempting to use another cylinder or pressure gauge. If pump is working
properly, check the pressure on the line. The relief valve may be by-passing fluid at too low pressures. If
cylinder is still not functioning properly, check the line for stoppage. The pistons in hydraulic cylinders are
virtually trouble-free, but occasionally one will have a scored wall and allow oil to flow around the piston. In this
case, replace the cylinder.
NOTE
: Refer to repair parts section on valve bank settings on individual relief cartridges.
HYDRAULIC MOTOR NOT WORKING
- Check lines for kinks or pinched place. If the motor is “bogging
down” under load, recheck the relief valve setting on the cutter valve - 2500 P.S.I.
HYDRAULIC VALVE
- Failures in the hydraulic system are almost always caused by other elements in the
system other than the valve; so the entire system should be checked before the valve is changed. A
malfunction In any hydraulic valve section will require replacement of that section (but not the replacement of
the valve bank) since the insides are honed to fit individually. Attachments such as the relief valves and detent
may be serviced individually.
STRUCTURAL MEMBERS
- Failure in structural members generally results from rough treatment. While they
are constructed to withstand abuse, they cannot be made strong enough to withstand abnormal abuse. The
factory does not warrant these parts to any extent other than in normal use in grass, weeds, brush, small
bushes, and small trees which the unit is designed to cut.