AJ Aircraft 93 AJ Laser 230z, Руководство по сборке

Страница: 24 / 25

aj-aircraft.com Page 19
Unfold the tab position tape markers you created. Flip
over the fuselage and drill holes in the cowl for the
mounting screws. (Be carefull not to drill into the tabs
and blind nuts. Install 4-40 screws and washers to finish
the installation.)
Horizontal Stabilizer Mounting
Run the elevator servo extension wires through the
conduit located inside the fuselage and then out the
sides of the fuselage. (Label the servo extensions so you
don’t get them mixed up.)
Apply a few drops for thin CA glue to the alignment pin
to ensure it’s secured. (Allow to dry before installing on
fuselage.)
Slide the horizontal stabilizer tube through the fuselage.
Attach an extension wire to the elevator servo lead.
Use a safety clip to secure the connection.
Slide the stabilizer and elevator on to the tube.
Use 4-40 screws and flat washers to secure it in
position.