AJ Aircraft 93 AJ Laser 230z, Руководство по сборке

Страница: 10 / 25

aj-aircraft.com Page 5
Assemble a control horn ball link (without a flange) to
the control horns using a socket head screw, washer
and nylon lock nut. Assembling the ball link to the
control horn at this step will help keep the control horn
halves aligned during installation. Insert the control
horn assembly into the surface again testing the fit.
Check the alignment of the control horn to the hinge
center line. The linkage hole in the control horn should
be aligned with the hinge centerline.
With the control horn in position apply painter’s
masking tape around the control horn base. Put the
tape up to the base edge. Not under or over it.
Remove the control horn leaving the tape in position.
Using a new hobby knife blade lightly cut through the
covering but not into the balsa sheeting.
Cut inside the tape edge about 1/16”.
Prepare all control surface and control horns before
gluing. Using 30 minute epoxy will provide plenty of
working time to glue in all control horns at one time.
Apply epoxy to the slots in the aileron. Use a pin to
help push epoxy down into the slot.
Apply epoxy to the control horn assembly and insert it
into the aileron slots.