AJ Aircraft 93 AJ Laser 230z, Руководство по сборке

Страница: 16 / 25

aj-aircraft.com Page 11
Slide the control horns into position and apply epoxy to
the opposite site to adhear the other base in position.
Assemble the alignment fixture with the control horn
and rudder making sure the control horns are square to
the rudder centerline.
After the epoxy has fully cured install the rudder onto
the fuselage. Slide the tail wheel assembly tiller rod
through the rod end mounted to the bottom of the
rudder. Align the hinges and thread the hinge wire
through all the hinges.
Tread the brass cable eyes about half way into the ball
links. The ball links with the flange will be connected to
the servo arm. The ball link without the flange will be
connected to the control horn.
Start the cable assembly at the servo end inside the
fuselage. Thread on 2 crush sleeves and the brass cable
eye.
Loop around the cable eye and go back through a crush
sleeve.
Loop around the first crush sleeve and back through the
sleeve again. Slide the second sleeve over the tail.
Adjust the loops and crimp the sleeves with the non-
serrated surface of standard plyers.