AJ Aircraft 93 AJ Laser 230z, Руководство по сборке

Страница: 13 / 25

aj-aircraft.com Page 8
The servo will be mounted inside the horizontal
stabilizer. The servo mounting screw holes are already
predrilled. The servo wire goes towards the front of the
stabilizer.
Fold the servo wire towards the top of the servo. Insert
the servo into the pocket. (It’s typically easier to get the
wire end of the servo in first.) Once the servo is fully
seated into the pocket insert servo mounting screws.
(Socket head screws or a magnet attached to your
screw driver may make inserting screws a little easier.)
Connect the servo to your receiver and battery. Turn on
your transmitter to center the servo. Attach the servo
arm square to the side of the servo. Don’t forget to
tighten the servo arm screw and the pinch bolt if you
servo arm has one.
Assemble the connection rod to a servo ball link with
the flange. Then connect the connection rod to the
control rod ball link. Make note that one end is a left
hand thread and the other is a right hand thread. Screw
the connection rod into each ball link equally.
Check the length of the assembly with the servo to
estimate the length. When you get close to the correct
length connect the flanged ball link to the servo arm
with a washer and socket head screw. (Always adjust
the connecting rod length with the servo powered up
and centered.)
Adjust the connecting rod to align the elevator and the
stabilizer. Because of the left and right threads on the
connecting rod the length of the rod can be adjusted
without disconnecting it from the servo or the control
horn.