AJ Aircraft 93 AJ Laser 230z, Руководство по сборке

Страница: 9 / 25

aj-aircraft.com Page 4
Control Horn Installation
Carefully locate the servo
pockets and aileron control
horn mounting slots in the
wings. Use a covering iron to
secure the covering around
these areas before cutting into
the covering. Use a new hobby
knife blade to cut though the
covering. Cut from the corners
of the pocket towards the
center of the pocket so the covering can be folded in
and sealed around the edges. Locate the aileron control
horn mounting slots and trim away the covering.
Carefully locate the elevator servo arm openings and
elevator control horn mounting slots. Use a covering
iron to secure the covering around these areas before
trimming away the covering.
Use sand paper to roughen the lower portion of the
control horns on both sides. Roughen one side of the
base plate. This will help the epoxy bond to the control
horn parts.
Test fit the control horn in the slot. Trim or file the slot
as needed to achieve a snug fit. Make sure the shoulder
of the control horn is fully seated down against the
control surface.
Notice that the control horn base is not symetrical. The
thinner edge should be positioned towards the hinge
line.