AJ Aircraft 2M AJ Acuity, Руководство по сборке

Страница: 13 / 21

aj-aircraft.com Page 12
Remove the rudder by sliding out the hinge pin. Trim the
covering from the control horn slot and follow the same
installation process used for ailerons.
The pull-pull cables can be removed, and the covering will
need to be patched.
Pull-Pull Rudder Control
The rudder is built with control horn slots for the push-
pull control system and the pull-pull control system. The
blue masking tape indicates the control horn locations.
The pull-pull control horn slots are located higher up on
the rudder.
Remove the rudder by sliding out the hinge pin. Trim the
covering from the control horn slot on both sides of the
rudder.
Use sandpaper to roughen up the end of the control horn
so the epoxy will adhere better.
Tests fit the control horns to the slots. Use a file to
modify the slot as needed. The control horn should be
symmetrical about the hinge line. A strait edge laid
across the control horn cable holes should be square to
the rudder centerline.
Apply masking tape around the control horn slot on both
sides of the rudder.
Use 30 minute epoxy to glue the control horns in place.
Check the alignment, peal the masking tape away, and
clean up with alcohol.
Check the alignment again and set aside for the epoxy to
cure. (When setting aside to dry position the rudder and
control horn so gravity does not reposition the control
horn for you.)
Reinstall the hinge pin and rudder onto the fuselage.