AJ Aircraft 2M AJ Acuity, Руководство по сборке

Страница: 7 / 21

aj-aircraft.com Page 6
Slip each of the aileron hinges into the wing. Align the
end of the aileron to the wing tip.
Push the aileron tight against the wing closing the gap
between the two of them. Move the aileron to its
maximum desired deflection (About 15°). Notice that the
hinges may pull out slightly. Experiment with the hinge
position finding the best fit before gluing.
Apply a piece of tape next to each hinge. This will help
you locate the hinges when you begin gluing them.
Check the aileron position at the hinges and wing tip
again before gluing.
Start with the hinge near the wing tip. Flex the aileron
slightly and apply a few drops of thin CA glue to one side.
Flex the aileron to its maximum desired position. Then
glue the opposite side.
Close the gap between the aileron and wing to the
desired position at the fuselage end of the wing half. Flex
the aileron slightly and apply a few drops of thin CA glue
to both sides of the hinge. Again, move the aileron back
and forth to check its position. Once the end hinges are
securely positioned you can apply a few drops of thin CA
to both sides of the remaining hinges.
Use the control horns from the “Wings” part bag.