AJ Aircraft 2M AJ Acuity, Руководство по сборке

Страница: 19 / 21

aj-aircraft.com Page 18
There are 2 areas in the bottom of the fuselage below the
rudder servo that can be cut open to provide air flow for
motor and speed controller cooling. Use a covering iron
to seal the edges of the areas. Cut through the center of
the covering. Fold it to the inside of the opening and
attach it using a covering iron.
Secure the canopy in position with 3mm socket head cap
screws and flat washers.
Slide the T-Canaliser through the canopy.
Measuring from both sides center the T-Canaliser in the
canopy.
Measure from the horizontal stabilizer on both side and
adjust as needed to ensure that it is parallel with the
horizontal stabilizer.
Tape the T-Canaliser in position when you have found the
perfect position. Remove the canopy and install 3 wood
screws to fasten the T-Canaliser to the canopy.