Airwell YCV280, Инструкция по установке и обслуживанию

Страница: 373 / 412

67 103
68 104
69 105
6A 106
6E 110
6F 111
70 112
72 114
71 113
73 115
74 116
6B 107
65 101
66 102
digital
tube
indication
on master
unit
indication
on wired
controller
(hex)
failure
code
definition
failure description remarks
DC motor
driving board
detecting out of
control
DC motor
driving board
EEPROM faulty
resume automatically 2 minutes and 50 seconds later
after unit stops.It occure 3 times in an hour, confirm the
failure.
resume automatically 2 minutes and 50 seconds later
after unit stops.It occure 3 times in an hour, confirm the
failure.
once
confirmation
, un-
resumable
once
confirmation
, un-
resumable
DC motor
driving board
over current or
current detector
damaged
voltage too low
protection of
DC motor
driving board
voltage too high
protection of
DC motor
driving board
DC motor
driving board
blocked
protection of
motor rate over
limitation
IPM modular
protection (F0)
compressor out
of control
radiator of
transducer
temp.too high
transducer
overload
voltage too low
of DC bus line
of transducer
voltage too high
of DC bus line
of transducer
communication
abnormal between
transducer and
control PCB
if current of DC motor driving board is over 5A, unit
alarms. 2 minutes and 50 seconds later after unit
stops, resume automatically, if it occurs three times in
an hour, confirm the failure.
if voltage of DC motor driving board is below 280V,
unit alarms. 2 minutes and 50 seconds later after unit
stops, resume automatically, if it occurs three times in
an hour, confirm the failure.
if voltage of DC motor driving board is over 400V, unit
alarms. 2 minutes and 50 seconds later after unit
stops, resume automatically, if it occurs three times in
an hour, confirm the failure.
fan motor rate can not be detected. 2 minutes and 50
seconds later after unit stops, resume automatically, if
it occurs three times in an hour, confirm the failure.
fan motor rate is higher than 1100 for 5 seconds, unit
alarms.
IPM modular over current, in short circuit, over heat,
voltage too low of control circuit.
in the course of compressor startup or running, the
unit can not detect the rotor position, or not connecting
compressor.
radiator temp. too high
output current of transducer is too high
voltage of power source is too low
voltage of power source is too high
communication is disconnected
once
confirmation
, un-
resumable
once
confirmation
, un-
resumable
once
confirmation
, un-
resumable
once
confirmation
, un-
resumable
once
confirmation
, un-
resumable
3 times in
an hour,
confirm
failure; once
confirmation
, un-
resumable
resumable
379