Airwell YCV280, Инструкция по установке и обслуживанию

Страница: 256 / 412

air outlet snow
-proof cover
air inlet snow
-proof cover
over 500mm
refrigerant pipe
over
200mm
over
200mm
M12 foundation screw
8~10HP: 4 pieces
12~16HP: 6 pieces
bottom plate
steel cable
20
steel cable
cushion
below 800mm
no obstacle within 2000mm
Position selection
1. Install adapter to change wind direction at the gas short circuit place.
2. When installing multiple units, there should be enough air inlet place
against air in short circuit.
3. In snowy area, install the unit under the bracket or the snow-proof cover
against the accumulative snow on the unit.
4. Do not install the unit at the place where the flammable gas will leak.
5. Install the unit at the strong enough place.
6. Install the unit at the flat place.
7. When the refrigerant pipe is leaded out from the bottom of the uni, the
below section should be a bracket with over 500mm height, see below
figure.
8. When being installed at the place with strong wind, set the air outlet of
the unit and the wind direction vertical. Also fix the unit with the screw.
9. When opening the electric box cover for maintenance, please fix the
cover with screw firmly.
Transportation
In transportation, please don't dismantle the packaging, and move the
unit to the installation location as closely as possible.
If the packaging must be dismantled, hang up the unit with rope
against damage.
Don't hang the unit only at two points. When hanging the unit, don't sit
on the unit. The unit should be upright.
When removing the unit with the forklift, put the fork into the special
hole at bottom of the unit.
When being hanged, the rope should be 4 pieces of steel cable with
over 6mm diameter.
Put the cushion at the contact section between steel cable and the
unit against the distortion or damage.
262