AirMan SDG60S-7A6, Инструкция по эксплуатации

Страница: 36 / 61

4. Operation
4
-
16
A030462
4.8.2 Gauge Indication while Operating
During normal operation, each indication of instruments is shown in the table below. Refer to the
table for daily checks.
Monitor lamp
Indicator
lamp Voltmeter
(V)
Frequency
meter
(Hz)
Ammeter
(A)
Engine
Oil
pressure
Water
temp.
Excessive
rotation
Air
filter
Oil
Fence Charge Leak
Before St
ar
ti
ng
up
Starter
switch
(RUN) 0 0 0
●
Off
●
Off
●
Off
●
Off
●
Off On
●
Off
50Hz
200
/400
50 144/72.2
During
Operation
(Full load)
60Hz
220
/440
60 157/78.7
50Hz
200
/400
52.5
During
Operation
(Unload)
60Hz
220
/440
62.5
0
●
Off
Be sure to check at times to see if gauges or each component of the
unit are properly working, or if there is any air-leak, oil-leak,
water-leak or fuel-leak etc.
The table above gives standard values. They may vary slightly
depending on the operating conditions and other factors.
In single-phase load operation, check the current of U, V, and W
phase with the ammeter, by turning the current selection switch.
When each current is unbalanced, change load connections so that
the current of U, V, and W, can be equally balanced. Also make sure
that the current of each phase does not exceed the rated one.
4.8.3 Panel light
The instruments are provided with transmission type illuminators. Switch “ON” the panel light so
that they may light on.
When illumination is not necessary, turn “OFF” the light. (If the machine is always operated with
the lamp switched “ON”, the lamp life can be shortened.)
4.8.4 Stopping Procedures
＜
Procedure
＞
①
Set the circuit-breaker on the instrument panel of the machine to “OFF” position.
②
After about five minutes’ cooling down operation, turn the starter switch to “STOP” position.