Aiphone JM-4MED, Руководство по эксплуатации

Страница: 14 / 32

14
Enabling/Disabling door release
[GENERAL] - [DOOR RELEASE]
You can make it possible (ENABLE) or not (DISABLE) to
release door locks from this station.
Set for Door 1 to Door 4 individually.
If "DOOR1" is set to "ENABLE", when receiving a call from
a door station or while monitoring an entrance,
1 and
2 are displayed on the screen. Touching 1
activates the door release device for Door 1.
If it is set to "DISABLE",
1 and 2 are grayed out
and disabled.
From HOME window, touch
1
SETTINGS →
GENERAL
→
DOOR RELEASE .
Enter the 4-digit PIN by using the touchscreen, then 2
touch ENTER .
“DOOR1” to “DOOR4” are displayed.
If a wrong PIN has been entered, an error message
*
is displayed. Enter correct PIN. (See page 10 for PIN
settings).
To change the setting for “DOOR1”, select “ENABLE” 3
or “DISABLE”.
Repeat for other door stations. 4
When the setting has fi nished, touch
5
ENTER .
Security settings [GENERAL] -
[ALARM SETTING] - [SECURITY SETTING]
These settings are available when the inputs 1, 2, and/or 3
*
are set to “SECURITY” by the [INSTALL] menu, and a sensor
is connected to each input.
Make the following settings for using the security function.
■
Setting the EXIT DELAY SETTING and
RETURN DELAY SETTING
Select an alarm delay to allow for enough time to vacate or
enter the premises before alarm is triggered.
Setting range: 0, 30, 60, 120, 300, 600 seconds
From HOME window, touch
1
SETTINGS →
GENERAL →
ALARM SETTING
→
SECURITY SETTING .
Touch
2
EXIT DELAY SETTING or
RETURN DELAY SETTING .
Touch the preferred time so that it is highlighted. 3
Use "
*
" or " " to scroll between times.
When the setting has fi nished, touch
4
ENTER .
■ Setting the ALARM PIN
Set an ALARM PIN if you need it to deactivate ARMED AWAY.
This setting is also applied to all sub master stations in this
*
system.
The default is “DISABLE” (no ALARM PIN is set or used).
From HOME window, touch
1
SETTINGS
→
GENERAL
→
ALARM SETTING
→
SECURITY SETTING .
Touch
2
ALARM PIN .
"1" to "9", and "0" are displayed.
Enter a 4-digit number as the ALARM PIN by
3
touching numbers one by one.
The entered ALARM PIN is displayed.
When the setting has fi nished, touch
4
ENABLE .
ALARM PIN is set to “ENABLE”.
To DISABLE the ALARM PIN
Proceed to step 3 above. Do not enter the ALARM PIN, but
instead touch
DISABLE
.