AHB marvel 8 mark III Series, Руководство пользователя

Страница: 51 / 70

MAINTENANCE MARVEL 8 MARK III
© MARVEL MFG. CO., INC. MANUAL 8SDN10871N (04/08)
G-7
23. Carefully observe the tracking of the blade
on the upper and lower band wheels while
the band wheel doors are open, making sure
that the blade is still no more than 1/16” (1.6
mm) from the flange of each band wheel as
it is operating. Blade tracking adjustments
are explained in the upcoming
MAINTENANCE section.
24. Carefully observe the upper and lower blade
guides for blade binding. Blade guide and
pressure block adjustments are explained in
the upcoming MAINTENANCE section.
25. Press and hold the CYCLE INTERRUPT /
COLUMN RETRACT pushbutton to stop
the blade and retract the column after
confirmation that the blade is tracking on the
band wheels and blade guides as noted
above.
26. Close the front blade guard and the band
wheel doors. The saw is now ready for
normal operation.
REPLACING THE WORK LAMP
BULB
The bulb in the work lamp is designed for use in
a rough and vibration prone environment. It
should be replaced with a similar bulb. The
recommended bulb is a Sylvania # 0-64156,
24V, 70W (Marvel # PEA-0135) bulb. Never
install a bulb larger than 70 watts.
The main electrical disconnect
switch must always be turned
to the "Off" position and
locked before adjusting,
servicing or cleaning the saw.
Failure to do so can result in
serious injury or death.
1. Caution should be taken when taking apart
the WORK LAMP assembly as the bulb and
lamp guard may be very hot. Unscrew the
lamp guard and remove old bulb.
2. When installing the new halogen bulb, it is
important to keep the bulb clean and oil free.
Do not touch the new bulb with your bare
fingers as the oils from your skin will be
deposited on the bulb, causing premature
failure of the bulb due to heat build-up in
that area.
3. When reinstalling the clear lamp guard,
make sure all gaskets, rings and hardware
are reinstalled to prevent fluids and dirt from
entering the lamp holder.
4. Turn main electrical disconnect switch to the
“ON” position and push the POWER
pushbutton to energize the saw’s controls
and turn on the new light.
COOLANT CHANGING
PROCEDURE
Under normal use, the coolant should be
changed and the saw chips should be cleaned
from the coolant reservoir every three months.
1.
Turn off the saw's main electrical
disconnect.
The main electrical disconnect
switch must always be turned
to the "Off" position and
locked before adjusting,
servicing or cleaning the saw.
Failure to do so can result in
serious injury or death.
2. Drain the coolant (approx. 20 gallons or 75
liters) into an appropriate container.
3. Clean the chips from the chip pan
Do not use compressed air to
clean the machine. Flying
debris can cause serious
injury.
4.
Remove the chip pan from the top of the
coolant reservoir.
WARNING
WARNING
WARNING