AHB marvel 8 mark III Series, Руководство пользователя

Страница: 40 / 70

MARVEL 8 MARK III OPERATION
F-2
© MARVEL MFG. CO., INC. MANUAL 8SDN10871N (04/08)
□
Inspect the band wheels and blade
guides and remove chips.
□
Inspect the blade wiper and chip brush.
Replace them if worn. See Maintenance
section.
□
Check the coolant level and condition.
Add coolant if necessary, change the
coolant if contaminated or excessively
dirty. Refer to "Coolant Changing
Procedures" in the Maintenance section.
MACHINE SET-UP
These steps should be performed for every new
cutting operation.
1.
Perform the pre-operation check list on page
F-1.
2. Position the following switches as indicated:
A.
Adjust the BLADE SPEED for the
material to be cut.
B. Set COLUMN AUTO RETRACT to Off
or On as desired
C. Set COOLANT to either ON, OFF or
AUTO as desired
D. Set COOLANT SYSTEM to either
FLOOD or optional MIST if supplied
with saw.
E. Set BLADE MODE to RUN
When tilting the column,
pinch points exist at the front
and rear of the column. Keep
body parts and other objects
clear of the column to avoid
injury and/or damage.
3. Manually tilt the saw frame to the desired
cut-off angle. Make sure the upper guide
arm and blade guard will not strike the vises
as damage to the saw will occur.
OPERATION
IMPORTANT: This section assumes the
operator is already familiar with the function
and location of the components described in
the Machine Description section, has
thoroughly reviewed and will adhere to all
safety warnings in this manual and those
attached to the machine.
Never operate the saw without
the rear cover properly in
place. Operating the saw
without the rear cover in place
exposes moving parts, belts,
and pulleys, creating risk of
serious injury and/or machine
damage.
1. Complete steps 1 through 3 of the "Machine
Set-up section above".
2. Turn the main disconnect switch on and the
air lock-out valve on.
Never load stock which
exceeds the machine's design
capacity. Personal injury or
machine damage will occur.
3. Position the work stock for a trim cut (if
necessary), or for the desired cut-off length
and firmly clamp it in the vise.
4. Adjust the carriage notching travel limit to
limit the saw column's travel and to shut off
the machine as desired for work stock
notching.
5. Press the POWER pushbutton to turn on the
work light, energize the controls and start
the coolant pump or the optional oil MIST
system.
6. If the saw is equipped with the optional
power TILT feature, use the TILT selector
CAUTION
WARNING
WARNING