AHB marvel 8 mark III Series, Руководство пользователя

Страница: 44 / 70

MARVEL 8 MARK III OPERATION
F-6
© MARVEL MFG. CO., INC. MANUAL 8SDN10871N (04/08)
12. Move the lower blade guide to the position
shown below to allow the 3º Blade Cant.
See the following illustrations.
A.
Remove the two (2) M10 bolts from the
blade guide mount.
B. Reposition blade guide & thread two (2)
M10 bolts into the second set of blade
guide tapped holes.
C. Rotate the blade 90º into the cutting
position by using the levers on the upper
& lower blade guides.
13. Secure the Air Ratchet to the Blade
Tensioner mechanism (see step 5 above) and
apply tension to the saw blade. See Blade
Changing section.
14. The actuator, prox carriage forward must be
moved when the blade is canted forward 3º.
To enable the saw to cut the full width of
stock given in saw specifications, complete
the following steps. See following photo for
clarification.
A.
Remove the two (2) M5 screws that
connect the prox actuatoir to the prox
actuator rail.
B. Move the prox actuator to the rear set of
holes on the prox actuator rail.
C. Insert two the two (2) M5 screws
through the prox actuator and tighten the
actuator to the rear set of holes.
Notching
Travel Limit
Rear Blade Travel Limit
(prox actuator and limit rail)
Carriage Forward
Prox Actuator