Agilent Technologies GS8210, Руководство по программированию, Страница: 312 / 352

7-12 N9360A Multi UE Tester GSM Programming Manual
7
Sample Program
7: Queries the manufacturer, model number, serial number and revision number of the firmware.
8-11: Displays the manufacturer, model number, serial number and revision number of the firmware on the status field.
14: Resets the Tester to the default setting for programming.
15: Activates the Loss correction function.
16: Sets the
Loss RF IN
value.
17: Sets the
Loss RF OUT
value.
20: Selects the
Radio System
to DCS1800.
21: Waits until the [Manual Test : Stand-by] screen is displayed on the Tester.
22: Displays message to an operator: Turn on the mobile phone.
23: Waits until the signaling state changes to Location Update.
24: Displays message to an operator: Wait until [Location Update] is passed.
25: Wait until
Location Update
is passed.
26: Executes the BS Call.
27: Waits until the signaling state changes to
talk/RF Test
(connection).
30: Displays the [Peak TX Power/Burst Timing/Power Ramp] screen on the Tester.
31: Starts the Peak TX Power measurement.
32: Waits until the measurement is completed.
33: Queries the measurement result of Peak TX Power.
34: Displays the measurement value and Pass or Fail result of Peak TX Power on the status field.
37: Displays the [Phase Error/Frequency Error] screen on the Tester.
38: Starts the Phase Error/Frequency Error measurement.
39: Waits until the measurement is completed.
40: Queries the measurement result of Phase Error.
41: Displays the measurement value and Pass or Fail result of Phase Error RMS on the status field.
42: Displays the measurement value and Pass or Fail result of Phase Error Peak on the status field.
43: Queries the measurement result of Frequency Error.
44: Displays the measurement value and Pass or Fail result of Frequency Error on the status field.
46: Executes the BS Release.
49: Displays Complete message on the status field.
Table 7-5 Program Comments
Line Description