Agilent Technologies 4395A, Ручное изменение

Страница: 547 / 575

Error Messages in Numerical Order
Error Messages in Numerical Order
0 - 100
+0 No error
The error queue is empty . Every error in the queue has been read (OUTPERRO? query) or the
queue was cleared by power-on or the 3 CLS command.
1 CAN'T SET RB W A UTO IN ZERO SP AN
The RBW A UTO mode cannot be selected in the zero span. The RBW must be specied
manually in the zero span. (spectrum analyzer mode only).
10 ADDITIONAL ST AND ARDS NEEDED
Error correction for the selected calibration class cannot be computed until all the necessary
standards have been measured.
11 CALIBRA TION REQUIRED
No valid calibration coecients were found when you attempted to turn calibration on .
12 NO CALIBRA TION CURRENTL Y IN PROGRESS
The
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
RESUME CAL SEQUENCE softkey is not valid unless a calibration is in progress . Start a new
calibration.
13 CALIBRA TION ABORTED
The calibration in progress was terminated due to a change of the active channel or stimulus
parameters .
14 NOT V ALID FOR PRESENT TEST SET
The calibration requested is inconsistent with the test set present. This message occurs in the
following situations:
A full 2-port calibration is requested with a test set other than an S-parameter test set.
A one-path 2-port calibration is requested with an S-parameter test set (this procedure is
typically used with a transmission/reection test set).
15 EXCEEDED 7 ST AND ARDS PER CLASS
A maximum of seven standards can be dened for any class .
16 CURRENT P ARAMETER NOT IN CAL SET
GPIB only . Correction is not valid for the selected measurement parameter .
17 B A CKUP D A T A LOST
Data checksum error on the battery backup memory has occurred. The battery is recharged for
approximately 10 minutes after power was turned on .
Messages-15