Agilent Technologies 34410A, Руководство пользователя

Страница: 63 / 144

34410A/11A User’s Guide 63
Features and Functions 2
Beeper
Normally, the multimeter will emit a tone from the front panel whenever
certain conditions are met (e.g. the multimeter will beep when a stable
reading is captured in reading hold mode). The beeper is factory set to
ON
,
but may be disabled or enabled manually.
Only when the beeper is
enabled
, the multimeter will emit a tone when:
1
A set
LO
or
HI
limit is exceeded in a limit test.
2 A stable reading is captured in reading hold mode.
3
A forward–biased diode is measured in the diode test function.
Disabling the beeper will cancel the tone in the three cases listed above.
However, the multimeter will always emit a tone when:
1 An error is generated.
2 The continuity threshold is exceeded.
3 A
SYST:BEEP
command is sent.
•
Front Panel Operation:
Press to display
UTILITY MENU
, and
press as needed until
MISC SETTINGS
is displayed. Press as
needed to display
BEEPER
, press or to select
OFF
or
ON
, and press
. Then step through or exit the configuration menu.
• Remote Interface Operation: The following command disables or enables the
front panel beeper:
SYSTem:BEEPer:STATe {OFF
>
0
>
ON
>
1}
The following command queries the state of the beeper:
SYSTem:BEEPer:STATe?
This query returns a “0” (OFF) or “1” (ON).
Refer to the Agilent 34410A/34411A Programmer’s Reference for
complete description and syntax for these commands.