AGFA SLIDEWRITER, Руководство пользователя

Страница: 32 / 49

3 - Disable Automatic
Calibration
4 - Calibrate to Assigned
Intensities
5 - Set the SCSI Device
Addresses:
CAUTION
This function causes the SlideWriter to turn off automatic
calibration between exposures.
Automatic calibration mode causes the SlideWriter to re-calibrate
the CRT's brightness levels automatically between images. This
ensures a high standard of accuracy in image brightness, but takes
time that this function can save.
This function causes the RED, GREEN, and BLUE lights to flash for a
few seconds while the SlideWriter calibrates. The SlideWriter will
calibrate only certain assigned levels in order to reduce the amount
of time consumed by the process.
The function lets the operator set up the SlideWriter device address
on the SCSI interface to the host computer. On power up, the
SlideWriter reads a default address from the DIP Switches inside the
Display Panel. Upon selecting this function, the current device
address will appear in the Current Exposure Display. To leave this as
the active address, press the SELECT Switch. Press the FUNCTION
Switch to increase the current address in steps of one up to "6"
(after "6" the display goes to zero and repeats the process). Press
SELECT to indicate the address desired.
The SlideWriter will not operate remotely from the host computer
unless it's SCSI address corresponds to the address programmed by
the host (refer to page 32 for additional information.)
29