AGFA SLIDEWRITER, Руководство пользователя

Страница: 10 / 49

3. Select
4. Ready
5. Remote
6. Fault and Error
7. Record
8. Red, Green, and Blue
9. Current Exposure
Display
NOTE
Press this switch to initiate the function displayed on the Current
Exposure Display.
This signal light announces that the SlideWriter is ready to accept
commands.
This signal light indicates that the SlideWriter is processing a
command from the host computer.
These lights indicate either a fault or an error condition. The
SlideWriter will issue a two-second-long warning alarm every fifteen
second until a system reset occurs. When either light is on, the
Current Exposure Display exhibits a primary hexadecimal error code.
(See page 34 for an explanation of each error code.)
This signal light indicates that the SlideWriter is recording an image.
These lights indicate which color is being recorded when the Record
light is on. When all three are off, the wheel is in the neutral
position. When all three are on, the wheel is changing from one
color to another.
When the three signal lights flicker randomly, the SlideWriter is
performing an automatic intensity calibration.
This operates under three conditions:
• During normal operation, the displayed digits indicate the film
frame the SlideWriter is currently exposing. A double dash ( - - )
means that the film has run out, that no film is present, or that the
"film load" function has not been set.
• A numerical display concurrent with an illuminated Fault or Error
light indicates the error code. (See page 34 for a detailed
explanation of error codes.)
• If the Function switch is pressed, the Current Exposure Display
shows the function number currently selected.
The display will flash continuously while in the function mode. This is
part of normal operation.
5