AGFA SLIDEWRITER, Руководство пользователя

Страница: 21 / 49

To load the film
(Refer to Figure 3-3.)
• Ensure that the SlideWriter is on.
• Ensure that the Shutter Speed Selector 1 is set to 'B'.
• Locate the film rewind knob 2 at the top left of the camera.
• Unfold the rewind crank 3 by pushing it in with your fingernail.
Pull the rewind knob, but do not push it back to its original posi-
tion. Open the camera back.
• Place a roll of film into the cavity 4 at the left of the camera
- back with the flat side up.
• Lock the cartridge in place by pushing the rewind knob down
and rotating it slightly so that it grips the spool.
• Pull the film leader out so it aligns with the film leader end mark
(dashed line) 5 .
• Lay the leading end of film flat along the back of the camera so
that the holes in the film fit over the sprocket teeth 6 and the
spool teeth 7 .
• Check that the film is properly placed and lays flat between the
two guide rails 8 .
• Take up any slack by rewinding the film into the cartridge.
• Close the camera back using light pressure until it clicks shut.
• Press the FUNCTION Switch on the SlideWriter until a '1' ap-
pears in the Current Exposure Display.
• Press the SELECT Switch. This activates the SlideWriter's load
film function. The camera will advance the film until a '1' ap-
pears in the frame counter 9 .
• If the rewind knob turns in the direction of the arrow 10 while
the film is being transported, it means the film is advancing
properly. If it does not, the film has not caught and you should
reattempt the loading procedure.
76