AGA GATEMASTER 900 HD, Руководство по установке

Страница: 15 / 23

15
Press any button of the remote transmitter for about 2 seconds. If the programming is
successful, the indicator LED on the board will flash four times and the buzzer will sound
once.
Note: After you press the LEARN button, if you don’t press a button on the remote within
5 seconds, the indicator LED will turn on and the Control Board will exit the learn mode.
IMPORTANT - Test the Operator Arms:
To keep things simple, a
t this
point it is recommended to test the operator arms before installing other accessories such as
a photo eye, exit sensor or keypad. This will prevent installation problems by keeping the
setup simple.
This is also a good tip whenever you are troubleshooting: Disconnect the accessories such
as the photo eye and exit sensor, make sure the gates are working, then connect the
accessories again one at a time and test.
Installing the AGA GATEMASTER Keypad
NOTE: Have the keypad in hand at the gate control box when programming. Do not mount
keypad on gooseneck mounting post yet.
Step 1: Program the keypad to the gate operator
Enter 0000* to enter programming mode. (0000 is the default code for programming)
(Note: The blue LED will light when in programming mode.)
Press 55#; keypad will beep once to confirm (This sends a signal to the receiver on the
Gatemaster control board.)
For a single gate press 01#
For a double gate press 02#
Press and release the red Learn button on the operator control board.
The control board will beep, and the digital display will show a number.
Step 2: Test using the default code
For a single gate press 1111# to activate the gate.
For a double gate press 2222# to activate the gates.
Step 3: Add a keypad code
Enter 0000* to enter programming mode (expect one long beep)
For a single gate press 01# (expect one beep)
For a double gate press 02# (expect two beeps)
Enter the new 4-digit pin followed by the # key; for example 2020#
(expect one long beep and one short beep to confirm)
Keypad will automatically exit programming mode