AGA GATEMASTER 900 HD, Руководство по установке

Страница: 13 / 23

13
The Charge Controller stops charging the batteries when they exceed a set
high voltage level, and re-enable charging when battery voltage drops back
below that level.
Press left/menu button to step through the settings.
The main display shows the current level of the battery in Volts.
Press the left/menu button once to see the Float or CV voltage.
Press and hold the left menu button until the display flashes, and then
press the right + or – buttons until it shows 28.5 V.
Press and hold the left/menu button to save the setting.
Battery backup
Battery backup is not required. In the event of a power failure there is a
manual release lever on the top of each operator arm which allows the
gates to be opened manually. Turn the key and lift the lever to move the
gate manually.
Battery backup may be added by installing two 12v 7ah batteries, wired in
series to produce 24V DC. (See wiring diagram.)
Connecting the Operator Control Cable
The operator arm is not pre-wired. Remove the rear cover on the operator
arm.
Use 2 conductor 14-gauge stranded wire and feed it up through the strain
relief nut.
Next, securely fasten the red (+) wire to the positive (+) “white”
terminal block and fasten the black (-) wire to the negative (-) “yellow”
terminal block.
Close the gear motor cover and tighten the two screws.