TECHNOPLAT CS/CW
TECHNOPLAT CS/CW TP
23.
Rest the disk on the little columns paying
attention to assemble the belt on the
pulley.
24.
Tighten screws
(E)
.
25.
Tension the belt through the tightener.
26.
Rotate manually the pre-stretch rollers in
both directions to completely adjust the
coupling between the belt and the
pulleys.
27.
Again check the tension of the belt and if
needed strain it properly.
28.
Re-assemble the casing
(A)
at the end of
the operation.
5.3. REEL CARRIAGE LIFTING CHAIN ADJUSTMENT
Proceed as indicated.
1.
Lift the spool carriage (with machine
operation set to "manual mode") up to
"top" end stroke.
2.
Switch the machine off.
3.
Loosen the screws and tilt the stake
resting it on the plate.
4.
Remove the guard
(B)
.
5.
Loosen the nuts
(C)
.
6.
Tighten the screw
(D) "M8x50 UNI
5739"
(element not supplied) with a
torque wrench (element not supplied) up
to the torque
3 Nm
.
7.
Re-tighten the nuts up to the surface of
the chain tightening pulley.
8.
Undo screw
(D)
.
9.
Refit the guard
(B)
.
10.
Re-position the stake vertically and
tighten the screws.
5.4. TABLE ROTATION CHAIN
ADJUSTMENT
Proceed as indicated.
1.
Remove the cover guard
(A)
.
2.
Loosen the fastening screws
(B)
of the
gear-box.
3.
Tighten the screw with a torque wrench
(element not supplied) up to the torque.
4.
Tighten the reducer fastening screws
(B)
when finished.
5.
Refit guard
(A)
.
44/79
