6
Secondary System Commands
Some preamplifiers can be set to a secondary system code. This is useful when there is one device in the audio
system that is pre-set to a system code used by another device.
Using the same procedure on the previous page, refer to the chart below to set a secondary system code.
Function
First
button
Second
button Acknowledge
Function
(sys code)
Third
Button
Confirmation
Change
STANDBY MUTE
LEDs blink 5 times Metis/Mimas 2 (19)
LEVEL DWN LEDs blink 5 times
Command
Calypso 2 (19)
MENU
LEDs blink 5 times
Set
Janus 2 (19)
INPUT
LEDs blink 5 times
Direct Commands
Using the same procedure on the previous page, refer to the chart below to set the system code to use direct
commands for the Metis, Janus and Rhea.
Function
First
button
Second
button
Acknowledge
Function
(sys code)
Third
Button Confirmation
Change
DISPLAY INPUT (>)
LEDs blink 5 times
Metis/Mimas Direct 1(16)
UP
LEDs blink 5 times
to Direct
Metis/Mimas Direct 2 (16) DOWN LEDs blink 5 times
Command
Janus Direct 1(16)
LEFT
LEDs blink 5 times
Set
Rhea Direct 1(21)
ENTER LEDs blink 5 times
LED Brightness
This setting will allow the user to set all of the LEDs to a desired brightness level.
To set the brightness, press and hold the
STANDBY
button. While holding Standby, press the
LEVEL UP
(
+
) button
and then let go of both. The LEDs will blink 5 times to acknowledge that this sub menu is active. Repeatedly
pressing the
UP
button increases the LED brightness, or repeatedly pressing the
DOWN
button decreases the LED
brightness, or ultimately turns them Off. The brightness will change only one level per button press and will be
visible in the buttons. The least bright is the factory default. To exit this sub menu, press the
MENU
button. The
LEDs will blink 5 times to confirm the user input and exit this sub menu.
When the LED brightness is set to off, the LEDs will only illuminate when entering a sub menu.
Motion Sense
The remote reads the ambient light level in a room. If it is low and the remote senses motion, all LEDs will turn on,
and stay on as long as there is continuous motion. When no motion is detected for the amount of time set in the
LED Timer sub menu, the LEDs will turn off. The Motion Sense feature can be turned on or off. The factory default
is On.
If disabled, to enable the Motion Sense feature, press and hold the
STANDBY
button. While holding Standby, press
the
UP
button and then let go of both. The LEDs will blink 5 times to acknowledge that this sub menu is active, and
the UP / Down buttons will be illuminated. Press the
UP
button. To disable this feature, while in this sub menu, press
the
DOWN
button. The LEDs will blink 5 times to confirm the user selection and exit this sub menu.