8
Battery Replacement
Should the internal battery need to be checked or replaced, remove the 4 screws on the rear panel. The battery will
be visible as should be its identification numbers. Remove and re-seat the battery by grasping it with 2 fingers in the
areas where there is no surrounding plastic, and pulling upwards. Upon re-inserting the battery, all LEDs should
illuminate temporarily unless the installed battery is dead or the remote is not activated (
Transport
mode).
Verify that the remote is activated by pressing and holding the
STANDBY
button. While holding Standby, press the
MENU
button, and then let go of both. The LEDs should blink 5 times to acknowledge that this sub menu is active.
The Up and Down LEDs should then be illuminated. If this is the case, press the
UP
button to activate the remote.
The LEDs will blink 5 times to confirm the user input, and exit this sub menu.
If the remote will not enter the
Activate
sub menu after the battery has been re-seated, replace the battery with a
new CR2450.
SPECIAL NOTE
: Regulations for disposal and recycling of batteries vary widely; local governments
may have additional requirements over those of national regulations.
DISPOSE OF OLD BATTERIES IN ACCORDANCE WITH YOUR LOCAL JURISDICTION.