5
Operation
Important note:
This product was initially shipped in the “Transport” state.
This is the same as being turned OFF, and is intended to preserve the
internal battery. It must be activated prior to initial use.
(Please refer to the
Remote activation section below)
Features
The remote can control a range of devices.
The remote has an internal motion sensor that will, in low light conditions, activate the LEDs when picked up or
otherwise moved. This feature can be turned on (default) or off.
The LED brightness can be adjusted in multiple steps from off to full brightness. When ON, the amount of time that
the LEDs are activated (on) after it senses a lack of motion in low light conditions, can be set by the user.
The software and hardware versions can be displayed by counting the number of times a specific LED illuminates.
The user can restore the factory defaults at any time.
The remote can be set to transmit several Direct commands. (Non toggle). This is useful for a learning remote or
programming a non-Aesthetix remote, or controller device.
Operation Detail
Remote Activation (Active/Transport Mode)
Initially the remote must be activated, or taken out of Transport Mode. To do this, press and hold the
STANDBY
button. While holding Standby, press the
MENU
button, and then let go of both. The LEDs will blink 5 times to
acknowledge that this sub menu is active. The Up and Down LEDs will be illuminated. Press the
UP
button to
activate the remote, or press the
DOWN
button to put it into Transport mode (Off). Regardless of whether or not the
remote is activated or put into transport mode, once the
UP
or
DOWN
button is pressed, the LEDs will blink 5 times
to confirm the user input, and exit this sub menu. Note: If the factory defaults are loaded, this feature will be On.
Command Set
This feature allows the user to select the Aesthetix device it will be controlling. The factory default is the Metis
preamplifier.
Changing the device to be controlled requires the user to press and hold the
STANDBY
button and, while holding
Standby, press the
MUTE
button. Then let go of both. The LEDs will blink 5 times to acknowledge that this sub
menu is active. Press the
UP
button to select (or verify) that the remote will control the Metis Preamplifier (System
code16). The LEDs will blink 5 times to confirm the user input, and exit this sub menu.
Use the chart below to control other Aesthetix products.
Function
First
button
Second
button
Acknowledge
Function
(sys code)
Third
button
Confirmation
Change
STANDBY
MUTE
LEDs blink 5 times Metis/Mimas (16) UP
LEDs blink 5 times
Command
Calypso (16)
DOWN
LEDs blink 5 times
Set
Callisto (16)
LEFT
LEDs blink 5 times
Janus (16)
RIGHT
LEDs blink 5 times
Rhea (21)
ENTER
LEDs blink 5 times
Romulus (20/19)
LEVEL UP
LEDs blink 5 times
