Aerotech Automation1 XC2, Руководство по оборудованию, Страница: 40 / 96

2.3.1. Primary Encoder Inputs
The primary encoder inputs are accessible through the Feedback connector. Use the
PrimaryFeedbackType [A3200: PositionFeedbackType or VelocityFeedbackType] parameter to configure
the XC2 to accept an encoder signal type.
Square Wave encoder signals: Section 2.3.1.1.
Absolute encoder signals: Section 2.3.1.2.
Sine Wave encoder signals (as permitted by the multiplier option): Section 2.3.1.3.
You cannot use a sine wave encoder with the -MX1 multiplier option as an input to the PSO. The -MX1
option does not generate emulated quadrature signals.
Refer to Section 2.3.1.4. for encoder feedback phasing.
Refer to Section 3.2. for the auxiliary encoder input on the AUX connector.
Table 2-13: Multiplier Options
Option Primary Encoder Accepts... Auxiliary Encoder Accepts...
-MX0 Square Wave or Absolute encoders Square Wave encoders
-MX1 Sine Wave, Square Wave, or Absolute encoders Square Wave encoders
IMPORTANT : Physically isolate the encoder wiring from motor, AC power, and all other
power wiring
Table 2-14: Primary Encoder Input Pins on the Feedback Connector
Pin # Description In/Out/Bi
3
+5V Power
(1)
N/A
6
Encoder Marker Reference Pulse - Input
Absolute Encoder Clock - Output
7
Encoder Marker Reference Pulse + Input
Absolute Encoder Clock + Output
8 Absolute Encoder Data - Bidirectional
14 Encoder Input
15 Encoder Cosine - Input
16
+5V Power (1)
N/A
17 Encoder Sine + Input
18 Encoder Sine - Input
19 Absolute Encoder Data+ Bidirectional
20 Signal Common N/A
21 Signal Common N/A
(1) The maximum combined current output is 500 mA.
2.3.1. Primary Encoder Inputs XC2 Hardware Manual
40 www.aerotech.com