OPERATION
3-1-39
[Tone Duration]
The default duration of 70 ms for each tone in the sequence can be changed by
pressing this key, entering the required duration value and pressing [ms].
[Tone Gap]
The default gap duration of 70 ms between each tone in the sequence can be changed
by pressing this key, entering the required gap length and pressing [ms].
[Start Delay]
The delay before the tone sequence starts and the gap between sequences can be
adjusted by pressing this soft key, entering the required delay time on the key pad and pressing
[ms].
[Mode Control]
Pressing this enables the user to assign the CALling tones to a selected type of
modulation, see Fig. 3-1-33. Modulation, on the selected channel, is turned off when the tones
are triggered and restored after the tones have been sent. Modulation on other channels is not
affected by the CALling tones and this allows sequential signaling tones to be combined with
sub-audible tones.
[NO mod]
This option effectively inhibits sequential tones. The tone
sequence can be sent between 1 and 9 times, set by
[No. of Repeats]
, every time the
[Send
Tones]
key is pressed. Setting the number of repeats to 10 allows the tones to be sent continually
under control of the
[Send Tones]/[Stop Tones]
key at the main menu.
[Select Standard]
Selection of alternative signaling standards is achieved by pressing this key to
access the
Select Standard Menu
.
[Store Tones]
Up to 20 sequence set-ups can be stored. Use the key pad to enter the store
location number and press [enter].
[Recall Tones]
To recall a tone sequence, use the key pad to select the required store location
and press [enter].
Fig. 3-1-33 CALling tones mode control menu (with [FM] selected)
No. of
Repeats
Total
FM
FM1
FM2
LOCAL
NO
Mod.
AM
EXIT
Calling Tones Mode Control
Assigned Modulation: Total FM
C0011
1 : SINGLE SHOT
Mode SINGLE
1 - -
2-9 : MULTIPLE
10 : CONTINUOUS
Φ
M
