AEQ
TALENT
15
4. CONFIGURATION AND OPERATION OPTIONS FROM
"
AEQ ControlPHOENIX
"
REMOTE
CONTROL SOFTWARE.
Configuration and operation of TALENT can be carried out remotely by means of "
AEQ
ControlPHOENIX
" software
(AEQ TALENT, Phoenix STRATOS, STUDIO, MERCURY,
VENUS, VENUS V2, VENUS V3 and ALIO Audiocodecs Configuration and Control Software).
The version that is provided together with the equipment (
2.2.1.47
or higher) can control up to
2
units
per software instance. If you need to manage more than 2 audiocodecs at the same time,
please contact AEQ sales department to purchase a multicodec-license for "AEQ
ControlPHOENIX".
Furthermore, version
2.2.1.47
(or higher) does
NOT
allow you to control units with CPU version
5.50
or higher and units with previous versions
SIMULTANEOUSLY.
In that case, these last
ones should be upgraded to version 5.50 or higher.
Please have the user manual of this application at hand. Install and configure it and add the
equipment to the controlled equipment list in order to follow the explanations provided in this
and following chapters step by step. This manual will describe particular TALENT options only,
as well as some important procedures, while the detailed operation is detailed in "AEQ
ControlPHOENIX" user’s manual.
4.1. Individual codec control window.
The individual codec control window is thoroughly described in chapter 6 of "AEQ
ControlPHOENIX" user’s manual. The screen corresponding to TALENT is as follows:
The name assigned to the device can be seen in the lower area of the window ("AEQ 03" in this
example), as well as the corresponding URI.
Additionally, we can see the equipment’s IP address. By clicking on this IP, an Internet browser
will pop up showing TALENT Web management window allowing, among other things, to
update firmware and obtain real-time IP traffic statistics when the channel/s is/are connected.
The left zone shows the general status of the communications channel, (CONNECTED, OK,
REGISTERING, etc), as well as the configured working mode and encoding and the remote
equipment’s data (IP address and port or name) in case it is connected. We can click in any of
both areas in order to show a window that provides all the details of the channel we have
clicked on:
