Adveco AGUADENS 210T, Инструкция по установке, использованию и техническому обслуживанию

Страница: 26 / 120

26 60T - 280T
COSMOGAS
Figure 6-2 - Feet to make it level
Figure 6-1 - Lifting system
6 - INSTALLATION - Setup
6.1 - Setup
To install the boiler correctly and easily, the following steps
must be scrupulously followed.
6.1.1 - Moving the boiler
WARNING! Use trolleys suitable for the type of
boiler to move it. Not doing this could cause serious
harm.
Position the boiler in the area selected for installation, moving
it using the pallet it is fixed to, taking care to keep it vertical
without making any sharp movements that might cause it to
overturn.
To remove the boiler from the pallet, undo the front (detail “C”
in figure 5-1) and rear (detail “D” in figure 5-1) fixing screws.
6.1.2 - Opening the package
The boiler is supplied in a cardboard package, fixed to the
pallet for transportation. Be careful when opening it, take the
cardboard box off by lifting it upwards, after detaching it from
the pallet.
6.1.3 - Lifting the boiler
For convenience during installation, a rod is provided (detail
“A” in figure 6-1) which enables the boiler to be lifted.

remove the top cover as in section 18.2;

hook lifting cables, “B” in figure 6-1, onto the rod, “A” in
figure 6-1 and lift the heating unit;
WARNING! The cables and lifting system must
be suitable for the purpose envisaged. In particular,
they must be able to bear the weight of the boiler which
you can check in section 19.

install the adjustable feet “A” to make the boiler level as
shown in figure 6-2.
Once the boiler is in the correct position the lifting cables
(detail “B” in figure 6-1) must be removed before the top
cover is put on.
A
A
020010.01.013
B
MIN 0
MAX 0,39 " (10 mm)
020010_01_030
B = Locking nut
AA
020021.01.009
B
A
020021.01.010
MIN
1 m