Advanticsys MPC-143, Руководство пользователя

Страница: 10 / 31

1.3
Page 10
MPC-
143. User’s Manual
5
“Discrete inputs” tab
Discrete inputs can be configured within this tab. They are shown organized in columns and
configuration parameters are shown in rows as follows:
o
"Enabled": user enable/disable discrete inputs to be used. In order to save
memory, it is recommend to only enable inputs in use.
o
"Current State": Graphical representation of current status (open/closed).
o
"Impulse quantity": Number of pulses counted from last reset.
o
"Impulse multiplier": user-defined multiplier. Values can be set from 1 to
1000.
o
"Value": Calculated from multiplying number of pulses counted (Impulse
quantity) and user-defined multiplier (Impulse multiplier).
o
"Debounce time": only pulses received
within one or more “Debounce time”
intervals are registered.
o
"Mode":
o
"Discrete Input": input works as a standard discrete input detecting
its current state (1 / 0)
o
"Impulse counter": input is used as a standard pulse counter,
storing the amount of pulses raised.
o
“Alarm signal”: input is used as an alarm input.
o
"Enable archiving": If enabled, events produced by discrete inputs are
stored in the datalogging archive.
o
"State to archive": Controller will increase counter and store it when one of
the following state is reached: "Open", "Close", "Both cases".
o
"Set initial amount of pulses": initial value for pulse counter can be set here.
NOTE: After configuration is completed, click on "
Set " button in order to save changes.
Figure 11.
“Discrete inputs” tab