Advanticsys MPC-143, Руководство пользователя

Страница: 5 / 31

1.3
Page 5
MPC-
143. User’s Manual
1
Introduction
This Manual will show you how to configure the MPC-143 datalogger/controller by using the
MPC-143 configurator software.
Figure 1. MPC-143 Configurator
2
Setting up connection to the device
In order to configure the controller, user must connect its PC to the device by using any of
the following interfaces:
1. USB port
2. RS232 interface
3. Through a GPRS connection (only accessible after configuring GPRS APN, user
and password inside the controller)
NOTE : Not all the models support above interfaces. Check your ordering code first.
2.1 USB/RS232 connection
Steps to be followed:
- Connect an USB cable class B or RS232 RJ11 to the correspondent port
- Open MPC-143 Configuration Tool
- Set up "
Connection Parameters " frame
o
Select "ModBus RTU" option under "Connection type"
o
Configure
“Bode” and “Parity” parameters; default values are:"19200" ,
"none"
o
Select COM port number assigned by your PC to the serial port
o
Click on
“
Get all
” to establish connection with controller.
2.2 GPRS Connection
Steps to be followed:
- Check GPRS antenna is properly connected to the device.