Advantech MIC-6314 Series, Руководство пользователя

Страница: 26 / 136

MIC-6314 User Manual 14
1.6.2 Serial Ports
MIC-6314 features one serial port and two serial ports routed to P5. These ports are
available as RS232 interfaces via RJ45 connectors on the front panel. RJ424/485
mode can be selected using the UART_SW switch. An RJ45 to DB-9 adaptor cable is
provided in the MIC-6314 accessories to facilitate connection to an external console
or modem devices. The BIOS Advanced Setup program described in Chapter 2 pro-
vides a user interface for enabling or disabling the ports and setting the port address.
Many serial devices implement the RS232 standard in different ways. If you have
problems with a serial device, check the connector pin assignments shown in Table
1.11. The IRQ and address range for these ports are fixed. However, if you wish to
disable the port or change these parameters later, you can do this in the system
BIOS setup.
1.6.3 Ethernet Configuration
MIC-6314 is equipped with a high-performance, PCI-Express-based, network inter-
face controller, the I350, which provides fully compliant IEEE802.3 10/100/
1000Base-TX Ethernet interfaces. Two GbE interfaces are connected to the front
panel, and another two GbE interfaces are routed to the backplane. The two GbE
connected to the backplane can be configured to SerDes. Please contact your local
Advantech representative to inquire about the availability of the SerDes SKU.
1.6.4 SATA Daughter Board Connector (HDD/Extension Module)
MIC-6314 provides one SATA interface via the HDD connector for a daughter card for
a CFast card, or optional onboard HDD. Four SATA (3.0 x3; 2.0 x1) interfaces are
connected to the RIO for additional SATA HDDs.
1.6.5 System Reset and BMC Reset Button
MIC-6314 features a system reset button located on the front panel. The system
reset button resets all payload and application-related circuitry, but does not reset the
system management (IPMI) related circuitry. A separate BMC reset button on the
front panel is provided for the BMC and related hardware.
1.7 Safety Precautions
Follow these simple precautions to protect yourself from harm and the products from
damage.
 To avoid electric shock, always disconnect the power from the VPX chassis
before manual handling. Do not touch any components on the CPU board or
other boards while the VPX chassis is powered on.
 Disconnect the power before making any configuration changes. The sudden
rush of power as a jumper is connected or a board installed may damage sensi-
tive electronic components.
 Always ground yourself to remove any static charge before touching the CPU
board. Be particularly careful not to touch the chip connectors.
 Modern integrated electronic devices, especially CPUs and memory chips, are
extremely sensitive to static electric discharges and fields. Keep the board in the
anti-static packaging when not installed in the chassis. When working with the
board, place it on a static dissipative mat. Wear a grounding wrist strap for con-
tinuous protection.