Unit Installation
NetVanta 3000 Series Hardware Installation Guide
88
Copyright © 2010 ADTRAN, Inc.
61200860L1-34AA
Figure 46. Installing DIMs
Instructions for Installing the DIMs
Step
Action
1
Remove power from the unit.
2
If the NIM is already in the NetVanta chassis, remove all cables, release the pins at both edges of the NIM
front panel and slide the module out of the chassis.
3
Carefully align the P1 connector on the NIM with the J1 connector on the DIM.
Using only
fingertip
pressure
so that neither circuit board bends or flexes, ensure that the connectors are firmly seated.
Secure the DIM to the NIM using the screws and standoff posts supplied. See
Figure 46
.
4
Slide the NIM with the DIM attached into the NetVanta chassis, continuing with the normal NIM installation
(refer to
Instructions for Installing the NIMs
below).
Instructions for Installing the NIMs
Step
Action
1
Remove power from the unit.
2
Slide the option module into the option slot until the module is firmly seated against the chassis.
3
Secure the pins at both edges of the module.
4
Connect the cables to the associated device(s).
5
Restore power to the unit.
