Unit Installation
NetVanta 3000 Series Hardware Installation Guide
78
Copyright © 2010 ADTRAN, Inc.
61200860L1-34AA
Figure 40. Wall Mounting the NetVanta 3120/3130/3200
Instructions for Wall Mounting
NetVanta 3120/NetVanta 3130/NetVanta 3200
Step
Action
1
Decide on a location for the unit. Keep in mind that the unit needs to be mounted at or below eye level so
that the LEDs are viewable.
2
Prepare the mounting surface by attaching a board (typically plywood, 3/4-inch to 1-inch thick) to a wall
stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not provide sufficient long-
term stability.
3
Install two #8 PAN head screws (1-inch or greater in length) into the mounted board, following these
guidelines and referring to
Figure 40
.
•
Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning by using
the location of the two keyed insets on the bottom of the unit as a guide.
•
Screws should be horizontally level with each other.
•
Leave approximately 1/4-inch of the screws protruding from the board to allow the heads of the screws
to slide into place in the unit’s keyed insets.
4
Slide the keyed insets on the bottom of the unit’s chassis securely onto the screws.
5
Proceed to the steps given in
Supplying Power to the Unit on page 83
.
