ADTRAN NetVanta 1534, Руководство по установке

Страница: 15 / 48

NetVanta 1534/1544 Series Physical Descriptions
61702590G1-34E Copyright © 2013 ADTRAN, Inc. 15
Power over Ethernet
The NetVanta 1534P unit provides the same basic functionality as the NetVanta 1534 product. PoE provides the
ability to detect attached powered devices (PDs), and deliver 48 VDC to the PD via Ethernet cabling. The
NetVanta 1534P is fully compliant with the IEEE 802.3af PoE and IEEE 802.3at PoE+ standards. By default,
the PoE switch discovers and provides power to IEEE-compliant PDs. The NetVanta 1534P also supports legacy
PDs.
NetVanta 1534 Series Shipping Contents
Each NetVanta 1534 Series unit is shipped in its own cardboard shipping carton. Open each carton carefully, and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in transit,
immediately file a claim with the carrier and contact ADTRAN Customer Service (refer to the
Support page on
the ADTRAN website at http://www.adtran.com/support ).
Domestic shipments of the NetVanta 1534 Series includes the following items:
• NetVanta 1534 base unit
• A detachable power cable with a grounded, three-prong plug
• Quick start guide
• Two 19-inch rack mounting brackets with four mounting screws
International shipments of the NetVanta 1534 Series includes the following items:
• NetVanta 1534 base unit
• All necessary power cords
• Quick start guide
• Two 19-inch rack mounting brackets with four mounting screws
NetVanta 1534 Front Panel Design
The NetVanta 1534 front panel is shown below. Table 1 on page 25 describes all of the LEDs, and
Appendix A on page 47 shows the connector pinouts.
Figure 1. NetVanta 1534 Front Panel Layout
Front Panel Features
Link/Activity LEDs
The link/activity LEDs labeled 1 through 24 are located above the 10/100/1000Base-T Ethernet
interfaces and indicates when there is activity on the interface. The link/activity LEDs labeled 25
through 28 indicate when there is activity on the SFP interfaces (located on the rear panel of the unit).
When the LED mode switch has been activated, these LEDs will display VCID (future release).
25
26
27
28
STAT
RPS
VCID
NetVanta 1534
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24