ADT iCenter 8142ADT, Руководство пользователя

Страница: 105 / 136

105
Trouble Conditions
Introduction to Trouble Conditions
Typical Trouble Displays
The word CHECK or TRBL on the touchpad's display, accompanied by a rapid
"beeping" at the touchpad, indicates that there is a trouble condition in the system.
To silence the beeping sound for trouble conditions, press any key.
A display of “CHECK” or “TRBL” accompanied by a display of "CALL SERVICE"
indicates that a problem exists with the system that eliminates some of the
protection. CALL F
O
R SERVICE IMMEDIATELY.
A display of “CHECK” or “TRBL" accompanied by a display of one or more zone
descriptors indicates that a problem exists with those zone(s)*. First, determine if
the zone(s) displayed are intact and make them so if they are not. If the problem has
been corrected, the display of the zone descriptor(s) and “CHECK” or “TRBL” should
disappear. If not, key an
O
FF sequence (Code plus
O
FF) to clear the display. If the
display persists, CALL F
O
R SERVICE IMMEDIATELY.
A display of “CHECK” or “TRBL” accompanied by a numeric display of “6XX,” where
XX = 01-32, indicates a trouble on a supervised relay (corresponding relay number
01-32).
A display of “CHECK” or “TRBL” accompanied by a numeric display of “8XX,” where
XX = 00-31, indicates a trouble on a peripheral device (connected to the panel’s
touchpad terminals) of a corresponding device address (00-31).
A display of “CHECK” or “TRBL” accompanied by a numeric display of “9XX,” where
XX = 00-99, indicates a system trouble exists (dialers, bell outputs, ground fault,
etc.). These zones are as follows:
988: 2nd RF Receiver – not receiving signals
990: 1st RF Receiver – not receiving signals
997: Polling Loop Short
•
A display of "C
O
MM. FAILURE" at the touchpad indicates that a failure has
occurred in the telephone communication portion of your system. CALL F
O
R
SERVICE IMMEDIATELY.
•
A display of "SYSTEM L
O
BAT", accompanied by a once per minute "beeping" at
the touchpad indicates that a low system battery condition exists. CALL F
O
R
SERVICE IMMEDIATELY.
•
A display of "L
O
BAT" and a zone descriptor, accompanied by a once per minute
"beeping" at the touchpad indicates that a low battery condition exists in the
wireless transmitter displayed. CALL F
O
R SERVICE IMMEDIATELY.