28
1.4.3 Media Weight Settings
Using a compatible media is critical for proper operation of the printer because the fuser operates
at extremely high temperatures. This guide will help you determine what media weight setting is
best for your job.
NOTE: Avoid rubber based adhesives, polypropylene, and polystyrene substrates. Any damage to
the image drums, transfer belt, fuser, or printer components caused by improper media or media
weight settings are not covered by warranty.
The media weight setting effects the speed at which the material feeds through the printer along
with the fuser temperature. The combination of these two variables are extremely important to
achieve optimal print quality and avoid reduced life of the consumables.
Media weight settings can range from “Ultra Heavy” to “Medium”. Choosing a ‘heavier’ setting will
feed the material at a slower rate. Using a ‘lighter’ setting will feed material through the printer at a
faster rate.
It is recommended to start with “Ultra Heavy” and work your way down the list. Below the media
weight choice is critical with different materials since each setting offers different speeds and fuser
temperatures which will greatly influence toner adhesion, registration, and overall quality. Change
the media weight settings in the following order to extend the life of the fuser and decide which is
best for your material.
- Ultra Heavy (slow)
- Label 1
- Ultra Heavy 2
- Ultra Heavy 3
- Heavy
- Light
- Medium Light
- Medium (fast)
To change the media weight settings with in the Wasatch SoftRIP :
1.
Click Setup (blue gears)
NOTE: MEDIA CHECK BOX MUST BE UNCHECKED AT ALL TIMES
2.
To the right of imaging configuration click “Edit”
3.
Click “Properties”
4.
Change the “Weight” dropdown to desired setting.
5.
Click OK
6.
It is recommended to save each profile as a descriptive name when settings are changed.