ADLY MOTO
ASSEMBLY INSTRUCTION
1.
Take out the battery and fill with acid liquid.
Pre-charge the battery will extend its life.
The preparation and charge procedure is based on the battery’s instruction.
2.
Install the front and rear wheels and parts in the following order:
A. 18×40×4.5mm washer
B. 18mm hex-bolt (torque 14 kg-m, 135 N-m)
C. Cotter pin (open up the end after installed)
D. Rubber cap.
3. Install the front bumper.
4. Set the handle bar into the lock-pin of the steering base.
Tie-up the 4 hex-socket bolts.
Install the front cover into the handlebar.
5.
Install battery with the red wire to positive (+) first and the black wire to the
negative (-).
Use rubber strip to fix the battery onto frame.
6.
Check the oil gage to see if the oil quantity is on the upper position.
The oil type is 10W/40 for normal condition.
It would be better for the engine to choose synthetic type.
Fill up unleaded gasoline to operate.
Be sure the arrow mark on the fuel valve arm
ΰ
petcock
α
is set into the correct
position.(ON).
7. Turn on the main switch and try to start-up the engine.
In order to use the electric starter, you need to check the following:
A.
Check the neutral indication light should be on.
B
Press the electric starter bottom to start.
